Preventive maintenance and healthma treadmill
Healthma treadmillMaintenance mainly includes the adjustment of the daily cleaning, running belt and running board of lubrication, etc, the right of running machine maintenance can not only prolong the service life of running machine, and can ensure the mechanical safety.
More than one, running belt and wedge take up tight degree of recognition method
When running and skid, sometimes it is difficult to determine is running belt itself needs when tight or wedge belt need adjustment.If running with both sides can only pull away from the plate 55-75 - mm, are running with the rise of tightness or can.However, when running with a skid, first adjust the following steps to determine running belt or wedge belt.
1. Cut off power supply, unscrew fixed on the shell of the screw, and then removed to protect the shell of the treadmill
2. Set the treadmill speed is about 3 km/h, with his feet firmly on the run, try to make running and stop turning.If you can make the running and stop, and drum before also don't continue to roll, but it's still continue to turn the wheel motor, the wedge belt need adjustment
3. Set the treadmill speed about 3 km/h, with his feet tightly on the run, try to make running and stop turning.If you can make the running and stop, but the former roller continue to roll, then ran to adjust.
Second, run up tight adjustment steps
1. The treadmill rotate at a speed of 5.6 km/h
2. Use 8 mm Allen wrench, about adjusting bolts are turning or half a circle a circle: run counterclockwise to adjust loose;Clockwise turn up tight to run with
3. If the adjusted by the recognition, in use process can still run a belt skid phenomenon, can repeat the above steps.
Three, running belt running deviation adjustment steps
In use process, running belt running deviation will be different, need to be adjusted, running and adjustment are as follows:
1. Place the treadmill level, treadmill at 5.6 km/h speed rotation
2. Run with a bias to the right, adjust the right bolt clockwise half a circle, then adjust the bolt counterclockwise rotation half a circle on the left
3. Run to the left, adjust the bolt clockwise (on the left half a circle, then adjust the bolt counterclockwise rotation half a circle on the right
4. If the adjusted by the recognition, in use process is still running deviation occurs, can repeat the above steps.
Fourth, running board lubrication
Running machine equipped with lubricated, often need to maintain running board, ran plate and running belt, the friction between has a great influence on your running machine service life, therefore should be periodically filling special lubricating oil according to the following procedure:
1. Cut off the running mechanical and electrical source
2. Wipe with a clean dry dishcloth between running board, with dust
3. Make the treadmill to stop running state, the silicone coating and run, run on a board
4. When filling oil, should not use the treadmill, don't get involved in running of equipment, such as clothing in order to avoid unnecessary damage.
Five, the running machine clean
1. The cleaning should be taken before running machine shutdown, and unplug the power plug
2. Usually run plate removal equipment surface and adhesion of dust
3. The frame, running belt surface can be used with soap liquid soft cloth to wipe, do not use household cleanser, naphtha, etc to wipe (instrument after wiping should make its dry up again after use.)
4. Often remove the protective shell, vacuuming the protective shell of dust.Short circuit (dust can make the PCB components, therefore should always clean up.)
